Sony CMR-PC2 USB, CMR-PC3 USB, CMR-PC4 USB Detaching the Camera, Removing the Mount, Removing the Camera from the Stand

Removing the Mount

Turn the stand’s rotation knob counterclockwise to loosen the suction mount, and then lift one edge of the suction mount to peel it away from the mounting surface.

Suction mount

Rotation knob

Removing the Camera from the Stand

Remove the camera from its stand as shown in the illustration below.

Camera

Stand

Detaching the Camera

Note

•If you detach your camera while the computer is powered on, be sure to perform the following procedures. If this is not performed correctly, there is a risk that the computer may fail to operate correctly.

•When you detach the camera while the computer power is off, step 1 is not required. However, when the USB cable is disconnected with the computer in the power saving mode, the system may not recognise the camera if the USB cable is plugged in again.

1

2

Close the software used with your camera.

Unplug the USB cable.

Note

•Unplugging by grasping a part of the cable may result in damage. Be sure to hold the connector section when unplugging.

•When using the camera monitor mount with the CMR-PC2 USB or the CMR-PC3 USB, pull the arm plate open with your fingers and remove the camera from the camera monitor mount.

15