Recording from the radio (continued)
1 Insert a recordable MD.
With the label side up, and the shutter on the righthand side
With the arrow 
pointing toward 
the deck
2 Press TUNER/BAND to select “FM” or “AM.”
3 Press TUNING MODE repeatedly until “PRESET” appears.
4 Press TUNING + or – to select the desired preset station.
The preset number scrolls in the display, followed by the frequency.
Frequency (or station name* or RDS station name**)
When you preset only one station, “ONE PRESET” appears in the display.
You can also select the preset numbers with the number buttons on the remote.
*The station name appears only if you have labeled the station (see page 63).
**European model only
5 Press MD REC z.
The MD deck stands by for recording and “REC” appears in the display.
6 Press MD NX.
Recording starts.
To stop recording
Press MD x.
Tips
•If noise is heard while recording an AM radio program, move the AM loop antenna to reduce the noise or connect a ground wire to the U terminal (see page 71).
•You can record the MD in monaural format. For details, see “Monaural recording” on page 42.
•To record
Note
If the MD is record protected, “C11” and “Protected” appear alternately and the MD cannot be recorded. Remove the MD, then slide the record protection tab to the closed position (see page 32).
Before pulling out the power cord
MD recording is completed when the MD Table of Contents (TOC) is updated. The TOC is updated when you eject the MD or press ?/1to turn off the system. Do not pull out the power cord before updating the TOC (while “TOC” is lit) or while updating the TOC (while “TOC” or “STANDBY” is flashing) to ensure a complete recording.
20