
Tuner
Severe hum or noise, or stations cannot be received. (“TUNED” or “ST” flashes on the display.)
Connect the antenna properly.Find a location and an orientation that provide good reception, and then set up the antenna again.
Keep the antennas, SiriusConnect Home tuner, and AC adaptor away from the speaker cords and the power cord to avoid picking up noise.
Connect a commercially available external antenna.Consult your nearest Sony dealer if the supplied AM antenna has come off the plastic stand.
Turn off nearby electrical equipment.The system cannot receive satellite channels at all.
Check that the XM
The receiving condition is not good. Move the antenna to the place where the condition is good.
Check that you subscribed to the desired satellite radio service (see page 12).
To change the AM tuning interval
The AM tuning interval is
All the AM preset stations are erased. To reset the interval to the factory preset, repeat the procedure.
To improve tuner reception
Turn off CD player power by using the CD power management function. By default, CD power is turned on.
1Press FUNCTION repeatedly to select the CD function, and then turn off the system.
2After “STANDBY” stops flashing, press /on the unit while holding down /CANCEL on the unit.
“CD POWER OFF” appears. With CD player power turned off, disc access time is increased. To turn on CD player power, repeat the procedure until “CD POWER ON” appears.
To reset the system to factory settings
If the system still does not operate properly, reset the system to factory settings.
Use buttons on the unit to reset the system to its factory default settings.
1Disconnect and reconnect the power cord, and then turn on the system.
2Press /CANCEL , DSGX and /at the same time.All
Others