Sony CPD-20SF2T5 manual Plug and Play, Use of the Tilt-Swivel, Specifications, Damper Wire

Plug and Play

This monitor complies with the DDC™1, DDC2B and DDC2AB which are the Display Data Channel (DDC) standards of VESA.

When a DDC1 host system is connected, the monitor synchronizes with the V. CLK in accordance with the VESA standards and outputs the EDID (Extended Display Identification) to the data line.

When a DDC2B or DDC2AB host system is connected, the monitor automatically switches to each communication.

DDC™ is a trademark of Video Electronics Standard Association.

Use of the Tilt-Swivel

With the tilt-swivel, this unit can be adjusted to be viewed at your desired angle within 90˚ horizontally and 20˚ vertically. To turn the unit vertically and horizontally, hold it at its bottom with both hands.

15°

45°

45°

5°

Specifications

Picture tube	0.30 mm aperture grille pitch
	20Ê inches measured diagonally
	90-degree deflection
Viewable image size	Approx. 388 × 292 mm (w/h)
	(15 3/8 × 11 1/2 inches)
	19.1” viewing image
Resolution	Horizontal: Max. 1280 dots
	Vertical: Max. 1024 lines
Standard image area Approx. 373 × 280 mm (w/h)
	(14 3/4 × 11 1/8 inches)
	or
	Approx. 350 × 280 mm (w/h)
	(13 7/8 × 11 1/8 inches)
Deflection frequency Horizontal: 30 to 85 kHz
	Vertical: 48 to 150 Hz
AC input voltage/current
	100 to 120 V, 50/60 Hz, 1.7 A
	220 to 240 V, 50 – 60 Hz, 1.2 A
Power consumption	Max. 150 W
Dimensions	Approx. 472 × 493.5 × 501 mm (w/h/d)
	(18 5/8 × 19 1/2 × 19 3/4 inches)
Mass	Approx. 29.5 kg (65 lb 1 oz)

Pin assignment

Video signal cable (HD15) (Male)

The cable accepts RGB video signals (0.714 Vp-p, positive), and SYNC signals.

1 2 3 4 5

6 7 8 9 10

11 12 13 14 15

EN

Damper Wire

Using a white background, very thin horizontal stripes on the screen are visible as shown on the illustration. These stripes are damper wires. These wires are attached to the aperture grille inside the Trinitron tube and are there to damp vibrations of the aperture grille in order to prevent them from influencing to the picture quality.

Damper wire

Approx. 8 cm

Approx. 8 cm

Pin No.	Signal	Pin No.	Signal
1	Red	8	Blue Ground
2	Green	9	DDC + 5V*
	(Composite
		10	Ground
	Sync on Green)
		11	—
3	Blue
		12	Bi-Directional
4	—		Data (SDA)*
5	DDC Ground*	13	H. Sync
6	Red Ground	14	V. Sync
7	Green Ground	15	Data Clock (SCL)*

*Display Data Channel (DDC) Standard by VESA.

Design and specifications are subject to change without notice.

9