Connecting the camera to your computer via the Cyber-shot Station

1Connect the Cyber-shot Station to your computer by the USB cable supplied with the Cyber-shot Station.

4

2Turn on the camera.

The USB connection between the camera and your computer will be established. Then you can transfer images to your computer. For further details, see the operating instructions supplied with the camera.

When the Cyber-shot Station is communicating with your computer using the USB cable, do not remove the camera from the Cyber-shot Station. Removing the camera may damage the images.

Care and maintenance

Clean the Cyber-shot Station with a soft cloth slightly moistened with water, and wipe the surface with a dry cloth. Do not use any type of solvent such as thinner, alcohol or benzine as this may damage the surface.

WARNING

Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

Replacing the button type lithium battery

*Do not use any batteries other than CR2025.

1Pull out the battery holder while pushing the tab on the holder.

2Take out the button type lithium battery from the holder.

3Put a new battery into the holder with its + side facing upward.

4Insert the holder into the remote control until it clicks.

12-GB