To charge the rechargeable battery without using the supplied speaker stand
/CHG
to DC IN 3V
AC power adaptor
to an AC outlet
1Connect the AC power adaptor to the DC IN 3V jack of your CD player and AC outlet.
2Press /CHG.
Charging starts.
To remove the battery
Remove the battery as illustrated below.
Note on the useful life of the rechargeable battery and when to replace it
If the battery is new or has not been used for a long time, it may not charge completely.
In that case, charge it until “Charging” disappears from the display and then use the player until the battery is completely depleted (“Low Battery” appears on the display). Repeat this procedure several times.
If the battery life is shorter by about half of a normal charge after trying this procedure, replace the battery with a new rechargeable battery.
Note on carrying the rechargeable battery
Use the supplied battery carrying case to protect against unexpected heat. If the rechargeable battery comes into contact with the metallic objects, heat or fire may occur due to a short circuit.
When using a dry battery
Use only the following dry battery type for your CD player:
• LR6 (size AA) alkaline battery
1Slide the OPEN switch to open the lid of your player.
2Open the battery compartment lid inside the player.
3Insert the LR6 (size AA) battery (not supplied) by matching the to the diagram in the battery compartment and close the lid until it clicks into place.
Checking the remaining power of the battery
The remaining power of the battery is indicated in the display as shown below. As the black indicator section decreases, the remaining power is depleted further.
“Low Battery” * * Beep sounds.
When the battery is depleted, replace it with a new one or charge the rechargeable battery.
Notes
•The display shows the approximate battery power remaining. For example, one section does not always indicate
•Depending on the operating conditions, the display may increase or decrease relative to the actual power remaining.
12