SPEAKER FORMATION

STANDARD

10 Press .11 Connect the calibration mic to the A.CAL MIC jack on the front panel.

Set up the calibration mic at the ear level using a tripod, etc. (not supplied). The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.

Calibration mic

E.g., DAV-HDX576WF

12 Press C/c to select [YES].

Note

•Make sure that the headphones are not connected to the unit or surround amplifier. You

cannot operate following Steps with the headphones connected.

13 Press.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.

•Before [AUTO CALIBRATION], install the surround amplifier in the appropriate location. If you install the surround amplifier in an improper location, such as another room, proper measurement will not be obtained.

•Avoid being in the measurement area and making noise during the measurement (which takes about 3 minutes), as it may interfere with measurement.

14 Unplug the calibration mic and press C/cto select [YES].

Note

•The environment of the room in which the system is installed may affect measurements.

•If measurement fails, follow the message then retry [AUTO CALIBRATION].

15 Press.

Quick Setup is finished. All connections and setup operations are complete.

To quit the Quick Setup

Press DISPLAY in any Step.

Tip

•If you change the position of the speakers, reset the speaker settings. See “Getting Optimal Surround Sound for a Room” (page 89) and “Calibrating the Appropriate Settings Automatically” (page 90).

•If you want to change any of the settings, see “Using the Setup Display” (page 68).

To recall the Quick Setup display1 Press FUNCTION +/– repeatedly until“DVD” appears in the front panel display.2 Press DISPLAY while the system is in stop mode.

The Control Menu display appears on the TV screen.

Started Getting

45US