ATo connect to a TV with the SCART input jack

Connect the system to your TV using the SCART (EURO AV) cord (not supplied).

Be sure to connect the SCART (EURO AV) cord to the EURO AV T OUTPUT (TO TV) jack on the system.

When you connect using the SCART (EURO AV) cord, check that the TV conforms to VIDEO signal or RGB signals. If the TV conforms to VIDEO signal, change the input mode of the TV to RGB signals. Refer to the operating instructions supplied with the TV to be connected.

BTo connect to a TV with the VIDEO IN jacks

Connect the video cord.

Yellow

CTo connect to a TV with the S VIDEO IN jack

Connect an S video cord (not supplied). When using the S video jack instead of the video jacks, your TV monitor must also be connected via an S video jack. S video signals are on a separate bus from the video signals and will not be output through the video jacks.

DTo connect to a TV with the COMPONENT VIDEO IN jacks

Connect a component video cord (not supplied). To use the COMPONENT VIDEO OUT jacks (Y, PB/ CB, PR/CR) instead of the video jacks, your TV monitor must be equipped with via COMPONENT VIDEO IN jacks (Y, PB/CB, PR/CR). If your TV accepts progressive format signals, you should use this connection and set the output channel of the system to progressive format (page 22).

Green

Blue

Red

Note

Only when DVD function is selected (by pressing FUNCTION repeatedly until “DVD” appears in the front panel display), the COMPONENT VIDEO OUT jacks output video signals.

When connecting to a standard 4:3 screen TV

Depending on the disc, the image may not fit your TV screen.

To change the aspect ratio, see page 82.

Started Getting

continued

21GB