Sony DAVHDX500, HDX501W and, 85US, x The measurement is OK, 5 Press X/x to select [YES], then press, 6 Press C/X/x/c to select [YES] or [NO], then press, Calibration starts

Connect the calibration mic to the A.CAL MIC jack on the front panel, and set it up at the ear level using a tripod, etc. (not supplied). The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic. Be quiet during the measurement.

AUDIO IN / A.CAL MIC

Calibration mic

5 Press X/x to select [YES], then press

.

Calibration starts.

Measuring. Please wait a moment.

Note

•Avoid being in the measurement area and making noise during the measurement (about one minute), to avoid measurement failure. During the measurement, test signals are output from the speakers.

•The environment of the room in which the system is installed may affect measurements.

•If an error message appears, follow the message, then select [YES].

An error message appears when:

–the headphones are connected.

–the calibration mic is not connected.

–front speakers are not correctly connected.

–surround speakers are not correctly connected.

–front and surround speakers are not correctly connected.

–subwoofer is not connected.

6 Press C/X/x/c to select [YES] or [NO], then press.

x The measurement is OK.						Advanced
Disconnect the calibration mic, then select
[YES]. The result is implemented.
	Measurement complete.					Settings
	FRONT L :		16ft	4.87m	0.0dB
	FRONT R :		16ft	4.87m	0.0dB
	CENTER :		16ft	4.87m	+ 1.0dB
	SUBWOOFER :		16ft	4.87m	+ 4.0dB
	SURROUND L :		10ft	3.04m	- 2.0dB
	SURROUND R :		10ft	3.04m	- 2.0dB	and
	“YES”.
	If OK, unplug calibration mic and select
		YES		NO		Adjustments

x The measurement is not OK. Follow the message, then select [YES] to retry.

Measurement failure.

Check speaker connection.

Retry?

YES

NO

Tip

•You can check the distance between the listening position and each speaker. See page 92.

continued

85US