If your camcorder is brought directly from a cold place to a warm place, moisture may condense inside your camcorder, on the surface of the disc, or on the pickup lens. This may cause a malfunction to your camcorder.
xIf moisture condensation has occurred
Leave your camcorder for about 1 hour without turning it on.
xNote on moisture condensation
Moisture may condense when you bring your camcorder from a cold place into a warm place (or vice versa) or when you use your camcorder in a humid place as follows:
• You bring your camcorder from a ski slope into a place warmed up by a heating device.
• You bring your camcorder from an air conditioned car or room into a hot place outside.
• You use your camcorder after a squall or a shower.
• You use your camcorder in a hot and humid place.
xHow to prevent moisture condensation
When you bring your camcorder from a cold place into a warm place, put your camcorder in a plastic bag and seal it tightly. Remove the bag when the air temperature inside the plastic bag has reached the surrounding temperature (after about 1 hour).
LCD screen•Do not exert excessive pressure on the LCD screen, as it may cause damage.
•If your camcorder is used in a cold place, a residual image may appear on the LCD screen. This is not a malfunction.
•While using your camcorder, the back of the LCD screen may heat up. This is not a malfunction.
xTo clean the LCD screen
If fingerprints or dust make the LCD screen dirty, it is recommended you use a soft cloth to clean it. When you use the LCD Cleaning Kit (optional), do not apply the cleaning liquid directly to the LCD screen. Use cleaning paper moistened with the liquid.
xOn adjustment of the touch panel
(CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the procedure below. It is recommended that you connect your camcorder to the wall socket using the supplied AC Adaptor during the operation.
1Turn on your camcorder, then press
(HOME).
2Touch (SETTINGS) t [GENERAL SET] t [CALIBRATION].
3Touch “×” displayed on the screen with the corner of the “Memory Stick Duo” or the like. The position of “×” changes.
Touch [CANCEL] to cancel.
If you did not press the right spot, try the calibration again.
bNotes
•Do not use a
•You cannot calibrate the LCD screen if it is rotated, or closed with the screen facing out.
Information Additional
Continued , 103