Troubleshooting

If you run into any problems using your camcorder, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact your Sony dealer.

Notes before sending your camcorder for repair

•Your camcorder may be required to initialize or change the current hard disk of the camcorder, depending on the problem. In the event of this, the data stored on the hard disk will be deleted. Be sure to save the data on the internal hard disk (see “Handycam Handbook” (PDF)) on other media (backup) before sending your camcorder for repair. We will not compensate you for any loss of hard disk data.

•During repair, we may check a minimum amount of data stored on the hard disk in order to investigate the problem. However, your Sony dealer will neither copy nor retain your data.

The power does not turn on.

•Attach a charged battery pack to the camcorder (p.7).

•Connect the plug of the AC Adaptor to the wall socket (p.7).

•Set the camcorder onto the Handycam Station securely (p.7).

The camcorder does not operate even when the power is set to on.

•It takes a few seconds for your camcorder to be ready to shoot after the power is turned on. This is not a malfunction.

•Disconnect the AC Adaptor from the wall socket or remove the battery pack, then reconnect it after about 1 minute. If the functions still do not work, press the RESET button (p.16) using a sharp- pointed object. (If you press the RESET button, all settings, including the clock setting, are reset.)

•The temperature of your camcorder is extremely high. Turn off your camcorder and leave it for a while in a cool place.

•The temperature of your camcorder is extremely low. Turn off the camcorder

and take it to a warm place. Leave the camcorder there for a while, then turn on the camcorder.

Buttons do not work.

•During Easy Handycam operation, available buttons/functions are limited. Cancel Easy Handycam operation. For details on Easy Handycam operation, refer to “Handycam Handbook” (PDF).

Your camcorder gets warm.

•This is because the power has been turned on for a long time. This is not a malfunction.

The power abruptly turns off.

•When approximately 5 minutes have elapsed while you do not operate your camcorder, the camcorder is automatically turned off (A.SHUT OFF). Change the setting of [A.SHUT OFF], or turn on the power again, or use the AC Adaptor.

•Charge the battery pack (p.7).

Pressing START/STOP or PHOTO does not record images.

•The playback screen is displayed. Set your camcorder to recording standby (p.11).

•Your camcorder is recording the image you have just shot on the hard disk. You cannot make new recording during this period.

•The hard disk of the camcorder is full. Delete unnecessary images (p.20).

•Total number of movies or still images exceeds the recordable capacity of your camcorder. Delete unnecessary images (p.20).

The recording stops.

•The temperature of your camcorder is extremely high/low. Turn off your camcorder and leave it for a while in a cool/warm place.

Troubleshooting

27