Getting started
Step 1: Charging the battery pack
CHG (charge) lamp | ACCESS lamp (Hard disk) |
|
| Battery pack |
DC plug |
|
DC IN jack | AC Adaptor |
| |
Power cord (Mains lead) To the wall outlet (wall socket) | |
You can charge the “InfoLITHIUM” battery pack (H series) after attaching it to your camcorder.
You cannot attach any “InfoLITHIUM” battery pack other than the H series to your camcorder.
1 Turn off your camcorder by closing the LCD screen.
2 Attachclicks. the battery pack by sliding it in the direction of the arrow until it
3 Connect the AC Adaptor and the power cord (mains lead) to your camcorder and the wall outlet (wall socket).
Be sure that the mark on the DC plug is facing down.
The CHG (charge) lamp lights up and charging starts. The CHG (charge) lamp turns off when the battery pack is fully charged.
4 When the battery is charged, disconnect the AC Adaptor from the DC IN jack of your camcorder.
See page 93 on recording and playing time.
When your camcorder is on, you can check the approximate amount of remaining battery power with the remaining battery indicator at the upper left on the LCD screen.
Contents of Table
Techniques Recording Useful
Index
16