Charging time

Approximate time (min.) required when you fully charge a fully discharged battery pack.

DCR-SR37E/SR38E/SR47E/SR48E/SR57E/SR67E

Battery pack

Charging time

NP-FH30 (supplied)

115

NP-FH50

135

NP-FH70

170

NP-FH100

390

DCR-SR77E/SR87E

 

Battery pack

Charging time

NP-FH50 (supplied)

135

NP-FH70

170

NP-FH100

390

When the battery pack is charged at 25 C (77 ˚F) (10 C to 30 C (50 ˚F to 86 ˚F) is recommended)

To remove the battery pack

Close the LCD screen. Slide the BATT (battery) release lever and remove the battery pack .

To use a wall outlet (wall socket) as a power source

Make the same connections as “Step 1: Charging the battery pack.” Even if the battery pack is attached, the battery pack is not discharged.

Charging the battery pack abroad

You can charge the battery pack in any countries/regions using the AC Adaptor supplied with your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.

Do not use an electronic voltage transformer.

Notes on the battery pack

When you remove the battery pack or disconnect the AC Adaptor, close the LCD screen and make sure that the (Movie) lamp/ (Photo) lamp (p. 19)/ACCESS lamp (p. 16)/access lamp (p. 60) are turned off.

The CHG (charge) lamp flashes during charging under the following conditions:

The battery pack is not attached correctly.

The battery pack is damaged.

In the default setting, the power turns off automatically if you leave your camcorder without any operation for about 5 minutes, to save battery power ([A.SHUT OFF]).

Contents of Table

Techniques Recording Useful

Index

17