Before beginning shooting, set the W. BAL switch to the A or B position. This automatically sets the camera to the white balance adjustment saved in the corresponding memory.
If white balance adjustment cannot be completed automaticallyThe warning message “AWB:NG” appears in the viewfinder.
Make the necessary corrections, then carry out the process again.
Warning messages for white balance adjustment
Message | Meaning and corrections to be made |
|
|
AWB:NG | Light level is too low. |
LOW LIGHT | • Increase the illumination level, open |
| the aperture, or use the GAIN switch |
| to increase the video signal level. |
| • Check the setting of the FILTER |
| control. |
| • After these checks, retry the |
| adjustment. |
|
|
AWB:NG | The subject is not white, or the lighting |
OVER LEVEL | level is too high. |
| • Use a white subject. |
| • Lower the illumination level, stop down |
| the aperture, or use the GAIN switch |
| to decrease the video signal level. |
| • Check the setting of the FILTER |
| control. |
| • After these checks, retry the |
| adjustment. |
|
|
AWB:NG | The color temperature is too low. Try |
C.TEMP.LOW | the following, in this order of |
| precedence. |
| (1) If the FILTER control is in position 3 |
| or 4, change it to position 1 or 2, |
| then retry the adjustment. |
| (2) Check that the subject is completely |
| white, then retry the adjustment. |
| (3) The color temperature may be |
| outside the range of the camera. Fit |
| an appropriate color temperature |
| conversion filter, then retry the |
| adjustment. |
|
|
AWB:NG | The color temperature is too high. Try |
C.TEMP.HI | the following, in this order of |
| precedence. |
| (1) If the FILTER control is in position 1 |
| or 2, change it to position 3 or 4, |
| then retry the adjustment. |
| (2) Check that the subject is completely |
| white, then retry the adjustment. |
| (3) The color temperature may be |
| outside the range of the camera. Fit |
| an appropriate color temperature |
| conversion filter, then retry the |
| adjustment. |
|
|
Message | Meaning and corrections to be made |
|
|
AWB:NG | Check the subject, then perform the |
TIME LIMIT | Auto White Balance adjustment again. |
| If AWB adjustment cannot be performed |
| on the second try, consult your Sony |
| dealer. |
|
|
AWB:BREAK | This message is displayed when the |
| AWB adjustment is canceled upon your |
| pressing the WHT/BLK switch to either |
| side while the adjustment is being |
| performed. |
|
|
WHITE:PRESET | The W. BAL switch is in the PRESET |
| position. |
| Move the W. BAL switch to the A or B |
| position. |
|
|
BARS | The camera is outputting a color bar |
| signal. |
| Move the OUTPUT/DCC switch to one |
| of the CAM positions. |
The camera provides two preset white balance settings, for instant shooting with approximately the correct adjustment.
There are also particular shooting conditions under which the preset values may give better results than the human eye adjustment.
1 Set the W. BAL switch to PRE.
The white balance is automatically adjusted for the preset white balance selected on page 3 <PRESET WHITE> of the OPERATION menu (see
page 60).
2 Press the 5600K button as required.
Settings and Adjustments 5 Chapter
Chapter 5 Adjustments and Settings | 75 |