Black Balance Adjustment
Correct adjustment of the black balance is important for optimum operation of a video camera. It is necessary when using the camera for the first time or after a significant period out of use, and also when there has been a sudden change in temperature.
The adjustment value is saved in memory, and readjustment is not normally necessary after powering the camera off or simply when lighting conditions change.
2 1
1 Move the POWER switch to the ON/SAVE position, and check that the OUTPUT/DCC switch is in one of the CAM positions.
2 Push the WHT/BLK switch in the BLK direction and release.
The lens aperture closes, and black balance adjustment is carried out.
During the adjustment the legend “ABB:EXECUTING” appears in the viewfinder.
ABB:EXECUTING
REFERENCE READ G
After a dozens of seconds the adjustment is complete, and the legend in the viewfinder changes to “ABB:OK.”
If you press the WHT/BLK switch toward either side while “ABB: EXECUTING” is being displayed, the black balance adjustment in progress
is canceled, and the camera returns to the previous state.
Notes
•When using a camera control unit or remote control unit, if the W/B BALANCE switch of the control unit is set to MANUAL, it is not possible to carry out black balance adjustment on the camera.
•The black balance cannot be adjusted while recording. Since the readout mode of the CCD changes during black balance adjustment, some disturbance may be generated in the video output signal from the camera. If automatic black balance is activated when any peripheral equipment is connected, noise may be generated or warning indication may light, but this is not a problem.
If black balance adjustment cannot be completed automaticallyThe warning message “ABB:NG” appears in the viewfinder.
Make the necessary corrections, then carry out the process again.
Warning messages for black balance adjustment
Message | Meaning and corrections to be made |
|
|
ABB:NG | The lens aperture did not close fully. |
IRIS | Check whether the lens cable is |
NOT CLOSE | connected properly, and whether there is |
| a fault in the lens. If a second attempt to |
| carry out the adjustment fails, consult |
| your Sony dealer. |
|
|
ABB:NG | The aperture opened during adjustment |
OVER FLOW | or there is a hardware error. |
| Close the aperture and try again. If this |
| fails, consult your Sony dealer. |
|
|
ABB:NG | Close the lens, then perform the Auto |
TIME LIMIT | Black Balance adjustment again. |
| If ABB adjustment cannot be performed |
| on the second try, consult your Sony |
| dealer. |
|
|
ABB:BREAK | This message is displayed when the ABB |
| adjustment is canceled upon your |
| pressing the WHT/BLK switch to either |
| side while the adjustment is being |
| performed. |
|
|
BARS | The camera is outputting a color bar |
| signal. |
| Move the OUTPUT/DCC switch to one of |
| the CAM positions. |
|
|
Settings and Adjustments 5 Chapter
Chapter 5 Adjustments and Settings | 77 |