Remote control
■Batteries installation
This product contains a CR Coin Lithium Battery which contains Perchlorate Material – special handling may apply. California residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/.
1While pushing the locking tab toward the center of the remote control, slide out the battery holder.
Back of remote control
Locking tab
2Remove the old batteries from the battery holder, insert two new batteries and then slide the battery holder back into the remote control.
Battery holder
Positive (+)
side up
Polarity (+) symbol
Battery type Locking tab
Precautions for battery use:
●Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage.
Caution:
●Do not use rechargeable batteries
●Danger of explosion if battery is incorrectly replaced.
●Replace only with the same or equivalent type.
●Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
●Installing the battery incorrectly may cause the unit to malfunction.
Notes concerning use:
●Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2X “CR 2032”, coin lithium battery.
●Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth.
●Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs.
●Keep the remote control away from moisture, heat, shock, vibrations and any conductive materials to avoid malfunction.
■ Test of the remote control |
| Use | |
Point the remote control directly at the remote sensor on the unit. | |||
The remote control can be used within the range shown | |||
below: |
|
| for |
Remote sensor |
| ||
ESOUND |
| Preparation | |
|
| 8” - 20’ |
|
15˚ | 15˚ | (0.2 m - 6 m) |
|
SKIP |
| PLAY MODE |
|
MENU | TV DISPLAY | SHUFFLE |
|
ENTER | ESOUND |
| |
CUE/ | CUR SOR | VOL UME |
|
REVIEW |
|
11