Using Accessories
Fitting optional microphones (operable with a 48 V supply) other than the
Use the same fitting procedure as for the
Slender microphones (19 mm (3/4 inch) diameter): use the microphone adaptor supplied with the
Connections and Fitting 2 Chapter
You can use the Anton Bauer Ultralight 2 or equivalent for this comcorder. Use a video light powered by 12 V with maximum power consumption of 30 W.
•If you connect the video light to the video light connector 9 on the camcorder (page 27) and set the LIGHT switch 3 to AUTO (page 16), you can turn the light on and off automatically as you start and stop the VCR operation.
•The output of the video light connector on the camcorder is controlled to 12 V even when the
camcorder is supplied with 12 V or more power (through the DC IN connector or battery pack). The brightness or color temperature of the light will not change according to voltage increase.
Notes
•Do not use a video light with power consumption of over 30 W.
•The brightness or color temperature of the light will change when the supplied voltage is under 12 V.
To fit the video light
Fit the video light to the camcorder grip or the | When using a video light with a long cable | |||||
accessory shoe on the viewfinder and connect the | You can pass part of the cable through the camcorder | |||||
video light cable to the video light connector. | grip. |
|
|
| ||
|
|
| ||||
1 Remove the cover of the | Projection B | Projection A | ||||
camcorder grip and break off |
|
|
|
|
|
|
projection A (see the figure). |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 Pass the cable through the grip as shown in the figure and replace the cover.
44 | Chapter 2 Fitting and Connections |