Controlling the TV or the AV Receiver (Amplifier) with the Supplied Remote
Adjustments and Settings
When you set the TV/DVD switch to TV, you can control your TV using the keys below.
TV/DVD switch |
|
| 1/u (POWER) |
1 | 2 | 3 |
|
4 | 5 | 6 | WIDE MODE |
7 | 8 | 9 | ENTER |
|
0 | TV/VIDEO |
| |
| TV CH |
| VOL |
| ENTER |
By pressing | You can |
|
|
1/u(POWER) | Turn the TV on or off |
|
|
TV/VIDEO | Select the input source for the TV |
|
|
VOL | Adjust the volume of the TV |
|
|
TV CH | Change the channel of the TV |
|
|
WIDE MODE | Switch the wide picture on or off |
|
|
Note
Depending on the TV, you may not be able to control your TV or to use some of the buttons above.
Controlling an AV receiver (amplifier)
with the remote
1Slide TV/DVD switch to DVD.
2Hold down 1/u(POWER), and enter your AV receiver’s manufacturer’s code (see the table below) using the number buttons. Then release 1/u (POWER).
Manufacturer | Code number |
Sony | 91, 88, 89 |
|
|
Denon | 84, 85, 86 |
|
|
Kenwood | 92, 93 |
|
|
Onkyo | 81, 82, 83 |
|
|
Pioneer | 99 |
|
|
Sunsui | 87 |
|
|
Technics | 97, 98 |
|
|
Yamaha | 94, 95, 96 |
|
|
Sony’s TV | 90* (default) |
|
|
*By setting the code number 90, you can adjust the volume of the TV even if the TV/DVD switch is on the DVD side, if you do not control an AV receiver (amplifier) with the remote.
Code numbers of controllable receivers (amplifiers)
If more than one code number is listed, try entering them one at a time until you find the one that works with your receiver (amplifier).
You can also change the sound volume of the AV receiver (amplifier) using VOL.
1 2 3
4 5 6
78 9 
0 
VOL
Note
Depending on the AV receiver (amplifier), you may not be able to control your AV receiver (amplifier).
58