Note
When connecting to a progressive TV, it is recommended that you use only pattern A. If you connect to your TV using both A and B, a special control signal transmitted via the SCART (EURO AV) cable may cause the signal to be switched to the SCART (EURO AV) jack.
AIf you are connecting to a monitor, projector, or AV amplifier (receiver) having component video input jacks (Y, PB/CB, PR/CR)
Connect the component via the COMPONENT VIDEO OUT jacks using a component video cord (not supplied) or three video cords (not supplied) of the same kind and length. You will enjoy accurate colour reproduction and high quality images.
If your TV accepts progressive 525p/625p format signals, use this connection and set the NORMAL/PROGRESSIVE switch on the rear panel to PROGRESSIVE to accept progressive video signals. The PROGRESSIVE indicator lights up when the player outputs progressive signals.
Green | Green |
Blue | Blue |
Red | Red |
Hookups
BIf you are connecting to a SCART (EURO AV) input jack
Connect the SCART (EURO AV) cord (not supplied). Be sure to make the connections firmly to avoid hum and noise. When you connect using the SCART (EURO AV) cord, check that the TV conforms to S video or RGB signals. Refer to the operating instructions supplied with the TV to be connected. Also, when you set “LINE” to “S VIDEO” or “RGB” under “SCREEN SETUP” in the Setup Display (page 64), use a SCART (EURO AV) cord that conforms to each signal.
CIf you are connecting to a video input jack
Connect the yellow plug of the audio/video cord (supplied) to the yellow (video) jacks. You will enjoy standard quality images.
Set the NORMAL/PROGRESSIVE switch on the rear panel to NORMAL when using this connection.
Yellow | Yellow |
White (L) | White (L) |
Red (R) | Red (R) |
Use the red and white plugs to connect to the audio input jacks (page 20).
DIf you are connecting to an S VIDEO input jack
Connect an S VIDEO cord (not supplied). You will enjoy high quality images.
,continued 17