Additional Information

Troubleshooting

If you experience any of the following difficulties while using the player, use this troubleshooting guide to help remedy the problem before requesting repairs. Should any problem persist, consult your nearest Sony dealer.

Power

The power is not turned on.

,Check that the mains lead is connected securely.

Picture

There is no picture/picture noise appears.

,Re-connect the connecting cord securely.

,The connecting cords are damaged.

,Check the connection to your TV (page 16) and switch the input selector on your TV so that the signal from the player appears on the TV screen.

,In the Setup Display, set “LINE” in “SCREEN SETUP” to the appropriate item that conforms to your system (page 64).

,The disc is dirty or flawed.

,If the picture output from your player goes through your VCR to get to your TV or if you are connected to a combination TV/ VIDEO player, the copy-protection signal applied to some DVD programmes could affect picture quality. If you still experience problems even when you connect your player directly to your TV, please try connecting your player to your TV’s S VIDEO input (page 16).

,You are playing a disc recorded in a colour system that is different from your TV.

,You have set the NORMAL/ PROGRESSIVE switch to PROGRESSIVE on the rear panel (the PROGRESSIVE indicator lights up) even though your TV cannot accept the progressive signal. In this case, set the NORMAL/PROGRESSIVE switch to NORMAL on the rear panel so that the PROGRESSIVE indicator turns off.

,You set the NORMAL/PROGRESSIVE switch to PROGRESSIVE on the rear panel (the PROGRESSIVE indicator lights up)

but did not connect your TV to the player’s COMPONENT VIDEO OUT jacks using a component video cord. Set to PROGRESSIVE only when you connect your TV to the player’s COMPONENT VIDEO OUT jacks using a component video cord (page 16).

,Even if your TV is compatible with progressive format 525p/625p signals, the image may be affected when you set the player to progressive format. In this case, set the NORMAL/PROGRESSIVE switch to NORMAL so that the PROGRESSIVE indicator turns off and the player is set to normal (interlace) format.

,If you set “LINE” to “RGB” in SCREEN SETUP (page 25, 64), the player outputs no component video signals.

Even though you set the aspect ratio in “TV TYPE” of “SCREEN SETUP,” the picture does not fill the screen.

,The aspect ratio of the disc is fixed on your DVD.

The picture is black and white.

,In the Setup Display, set “LINE” in “SCREEN SETUP” to the appropriate item that conforms to your TV (page 64).

,Depending on the TV, the picture on the screen becomes black and white when you play a disc recorded in the NTSC colour system.

,If you are using a SCART (Euro AV) cord, be sure to use one that is fully wired (21- pins).

Sound

There is no sound.

,Re-connect the connecting cord securely.

,The connecting cord is damaged.

,The player is connected to the wrong input jack on the amplifier (receiver) (page 21, 22, 23).

,The amplifier (receiver) input is not correctly set.

,The player is in pause mode or in Slow- motion Play mode.

,The player is in fast forward or fast reverse mode.

,If the audio signal does not come through the DIGITAL OUT (OPTICAL* or COAXIAL) jack, check the audio settings (page 67).

Information Additional

,continued 69