Adjusting the speaker volume
1After you stop playback, select “SPEAKER SETUP” in the setup display.
2Select “TEST TONE” and set “TEST TONE” to “ON.”
You will hear the test tone from each speaker in sequence.
3From your listening position, select “BALANCE” or “LEVEL” and adjust the value of “BALANCE” using </, and “LEVEL” using M/m.
The test tone is emitted from both left and right speakers simultaneously.
4Select “TEST TONE” and set “TEST TONE” to “OFF” to turn off the test tone.
To adjust the volume of all the speakers at one time
Use the receiver’s (amplifier’s) volume control.
Controlling Your TV or AV Receiver (Amplifier) with the Supplied Remote Z
By adjusting the remote signal, you can control your TV or AV receiver (amplifier) with the supplied remote. The default setting is to control Sony TVs with the g mark.
TV ?/1
|
|
| TV |
Number | 1 | 2 | 3 |
4 | 5 | 6 | |
buttons | 7 | 8 | 9 |
|
| 0 |
|
Controlling TVs or AV receivers
(amplifiers) with the remote
Hold down TV ?/1, and enter your TV’s or AV receiver’s manufacturer’s code (see the table on the next page) using the number buttons. Then release TV ?/1.
Code numbers of controllable TVs or AV receivers (amplifier)
If more than one code number is listed, try entering them one at a time until you find the one that works with your TV or AV receiver (amplifier).
Notes
•If you enter a new code number, the code number previously entered will be erased.
•When you replace the batteries of the remote, the code number may be reset to the default setting. Reset the appropriate code number.
Adjustments and Settings
61