5STOP button
To stop recording or playback, press this button, turning it on.
When you stop playback, the unit switches either to still playback or to
Fault display function
The STOP button flashes in the following cases related to reference signals:
•When F2 (OUTREF) is set to INPUT on function menu page 4, and there is no input video signal.
•When F2 (OUTREF) is set to REF in function menu page 4, and there is no external reference signal input or the input external reference signal is not synchronized to the input video signal.
6F FWD (fast forward) button
To fast forward the tape, press this button, turning it on.
7PLAY button
To start playback, press this button, turning it on.
To operate in capstan override mode
Hold down this button, and turn the search dial.
For details of capstan override mode, see page
1ASSEMBLE button
Press this button, turning it on, to carry out assemble editing 1).
All signals (video signals, audio signals, time code signals, and so on) are recorded together.
Press the button again, turning it off, to exit from assemble editing mode.
Note
When even one of the INSERT buttons is lit, the ASSEMBLE button does not work. To use the ASSEMBLE button, turn off all the lit INSERT buttons.
2INSERT buttons
Press the corresponding button, turning it on, to select a signal for insert editing 2). Press the button again, turning it off, to cancel the selection.
VIDEO button: Selects the video signal.
TC (time code) button: Selects time code.
CH1 to CH4 (audio channels 1 to 4) buttons: Select the signals on audio channels 1 to 4.
CUE button: Selects the cue audio signal.
Note
When the ASSEMBLE button is lit, none of the INSERT buttons work. To use INSERT buttons, press the ASSEMBLE button, turning it off.
Parts of Function and Location 2 Chapter
8SERVO indicator
Lights when the drum servo and capstan servo are locked.
9REW (rewind) button
To rewind the tape, press this button, turning it on.
q; Editing mode setting section
1ASSEMBLE button
ASSEMBLE |
|
| INSERT |
| |
VIDEO TC | CH1 | CH2 | CH3 | CH4 | CUE |
2INSERT buttons
qa ALARM indicator and KEY INHI indicator
ALARM indicator
This lights when a hardware error is detected on the unit, and goes off when the error is resolved.
When this indicator is lit, an error message appears in the time data/menu display section. If you are using the SDI OUTPUT 3 (SUPER) or COMPOSITE VIDEO OUTPUT 3 (SUPER) connector, then when the setting of F4 (CHARA) in function menu page 4 is ON, the error message also appears on the monitor screen.
For details on error messages, refer to Section
..........................................................................................................................................................................................................
1) Assemble editing: Editing in which new video/audio is | 2) Insert editing: Editing in which new video/audio is added |
added in sequence to the end of existing recorded video/ | to an intermediate position of existing recorded video/ |
audio. | audio. |
Chapter 2 Location and Function of Parts |