Additional settings (OPTION)

You can manually degauss (demagnetize) the monitor, change the menu position, set the power saving delay time, and lock the controls.

1Press the joystick.

The main MENU appears on the screen.

2Move the joystick to highlight OPTION and press the joystick again.

The OPTION menu appears on the screen.

3Move the joystick to highlight the desired adjustment item.

Adjust the selected item according to the following instructions.

Degaussing the screen

The monitor is automatically demagnetized when the power is turned on.

To manually degauss the monitor, first move the

joystick up or down to select (MANUAL DEGAUSS). Then move the joystick to the right.

The screen is degaussed for about 3 seconds. If a second degauss cycle is needed, allow a minimum interval of 20 minutes for the best result.

Changing the menu’s position.

Change the menu’s position if it is blocking an image on the screen.

To change the menu’s on-screen position, first movethe joystick up or down to select (OSD H POSITION)

for horizontal adjustment, or (OSD V POSITION) for vertical adjustment. Then move the joystick to the left or right to shift the on-screen menu.

Changing the power saving delay time.To adjust the time it takes to enter the power savingmode, first move the joystick up or down to select ZZ...

(PWR SAVE DELAY). Then move the joystick to the left or right to select the desired time.

If you select OFF, the monitor does not enter power saving mode. See page 15 for more information about the monitor’s power saving capabilities.

Locking the controls.To protect adjustment data by locking the controls, first

move the joystick up or down to select (CONTROL LOCK). Then move the joystick to the right to select LOCK.

Only the 1(power) switch, EXIT, and (CONTROL LOCK)

of the OPTION menu will operate. If any other items are

selected, the mark appears on the screen.

To cancel the control lock

Repeat the procedure above and set (CONTROL LOCK) to

UNLOCK.

Resetting the adjustments

This monitor has the following three reset methods. Use the RESET button to reset the adjustments.

RESET

Resetting a single adjustment item

Use the joystick to select the adjustment item you want to reset, and press the RESET button.

Resetting all of the adjustment data for the current input signal

Press the RESET button when no menu is displayed on the screen. Note that the following items are not reset by this method:

•on-screen menu language (page 8)

•on-screen menu position (page 14)

•power saving delay time (page 14)

•control lock (page 14)

Resetting all of the adjustment data for all input signals

Press and hold the reset button for more than two seconds.

Note

The RESET button does not function when (CONTROL LOCK)

is set to LOCK.

14