Type of trouble and their solutions
Symptom | Cause and/or Corrective Actions |
The melody or beep sounds for | • Moisture condensation has occurred. |
five seconds. | c Remove the cassette and leave your VCR for at least one hour |
| to acclimatize (p. 201). |
| • Some troubles have occurred in your VCR. |
| c Remove the cassette and insert it again, then operate your |
| VCR. |
While editing using the i.LINK | • Remove the i.LINK cable (DV connecting cable), and connect it |
cable (DV connecting cable), the | again (p. 69). |
picture cannot be monitored. |
|
No function works even though the power is on.
•Disconnect the power cord (mains lead) of the AC power adaptor or remove the battery, then reconnect it after about one minute. Turn the power on. If the functions still do not work, press the RESET button on the backside of your (recording) VCR using a
While charging the battery pack, the | • Charge is completed. |
POWER ON/CHARGE lamp does | • The battery pack is not properly installed. |
not light up. | c Install it properly (p. 15). |
You cannot charge the battery pack. | • The POWER switch is not set to OFF (CHG). |
| c Set it to OFF (CHG) (p. 16). |
While charging the battery pack, the • The battery pack is not properly installed. | |
POWER ON/CHARGE lamp | c Install it properly (p. 15). |
flashes. | • Something is wrong with the battery pack. |
| c Please contact your Sony dealer or local authorized Sony |
| service facility. |
Image data cannot be recognized | • The USB cable was connected before installation of the USB |
with the USB connection. | driver was completed. |
| c Uninstall the incorrect USB driver and |
| driver (p. 98, 151). |
| • The setting of USB MODE switch is not correct. |
| c Set USB MODE switch correctly (p. 99, 152). |
The cassette cannot be removed | • Moisture has started to condense in your VCR (p. 201). |
even if the cassette lid is open. |
|
нeиcпpaвноcтeй Уcтpaнeниe Troubleshooting
179