Sony HTSS2000, HT-SF2000 When error codes appear, To rectify the error, When you select “WARN CHK”, Item, SAVE, EXIT, 28GB, RETRY, PHASE, LEVEL, process, WARN CHK, DISTANCE

2 Press V/v repeatedly to selectthe item. Then, press .

Item	Explanation
RETRY	Performs the Auto
	Calibration again.
SAVE	Saves the measurement
	results and exits the setting
	process.
WARN CHK	Displays warning
	concerning the
	measurement results. See
	“When you select “WARN
	CHK”” (page 28).
PHASE	Displays the phase of each
	speaker (in phase/out of
	phase). See “When you
	select “PHASE”” (page 29).
DISTANCE	Displays the measurement
	result for speaker distance.
LEVEL	Displays the measurement
	result for speaker level.
EXIT	Exits the setting process
	without saving the
	measurement results.

3 Save the measurement result.Select “SAVE” in step 2.The measurement results are saved.

When error codes appear

Try the remedies and perform the Auto Calibration again.Error code Cause and remedies

ERROR 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and perform the Auto Calibration again.

If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected.

ERROR F 33 • None of the front speakers are connected or only one front speaker is connected.

•The optimizer microphone is not connected.

Error code Cause and remedies

ERROR SR 33 Either the left or right surround speakers is not connected.

ERROR SW 33 Sub woofer is not connected. Connect the sub woofer to the SUBWOOFER terminal.

ERROR 33 Wrong speaker detection due to noise. Make sure the environment is quiet during Auto Calibration.

To rectify the error

1Record down the error code.2Press , “RETRY Y” appears on the display.3Rectify the error.For details, see “When error codes appear” above.4Press to perform Auto Calibration again.

When you select “WARN CHK”

If a warning on the measurement result is present, detailed information is displayed.

Press to return to step 2 of “Confirming/saving the measurement results”.Warning code Explanation

WARN 40 The Auto Calibration has completed. However, the noise level is high. You may be able to perform the Auto Calibration properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the Auto Calibration in a quiet environment.

WARN 41 The sound input from the optimizer microphone is out of the acceptable range. It is louder than the loudest sound that can be measured. Try to perform the Auto Calibration when the environment is quiet enough to allow proper measurement.

WARN 42 The volume of the receiver is out of the acceptable range. Try to perform the Auto Calibration when the environment is quiet enough to allow proper measurement.

28GB