Video
There is no picture or an unclear picture appears on the TV screen or monitor.•Make sure you have connected the video output of your video component to the TV.
•Move your audio components away from the TV.
The source image input to the HDMI jack on the receiver is not output from the TV.
•Check the HDMI connection.
•Depending on the playback component, you may need to set up the component. Refer to the operating instructions supplied with each component.
Tuner
The FM reception is poor.•Use a
Outdoor FM antenna
Receiver
AM
Ground wire (not supplied)
ANTENNA
To ground
•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.
•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning (page 50).
•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).
•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 51).
RDS does not work.a)•Make sure that you are tuned to an FM RDS station.•Select a stronger FM station.The RDS information that you want does not appear.a)•Contact the radio station and find out whether they actually provide the service in question. If so, the service may be temporarily out of order.
a)Models of area code CEL, CEK only.
Remote control
The remote does not function.•For receiver operation, you can only use the DISPLAY button when the TUNER input is selected.
•Point the remote at the remote sensor on the receiver.•Remove any obstacles in the path between the remote and the receiver.•Replace all the batteries in the remote with new ones, if they are weak.•Make sure you select the correct input on the remote.•The VIDEO 3 button on the remote is not available for receiver operation.