73
DSR Series
*1: Select whether or not to specify CHANNEL. (Ignore Bit even when it is 1. However match Data’s
offset.)
0 : Do not specify CHANNEL.
1 : Specify CHANNEL.
*2: Select whether or not to specify the START position.
0 : Do not specify the START position.
1 : Specify the START position.
*3: Select whether or not to specify DURATION. (Ignore Bit even when it is 1.)
0 : Do not specify DURATION.
1 : Specify DURATION.
*4: Select whether or not to enable ENDLESS MODE. (Specifying this Bit activates Repeat Play.)
0 : ENDLESS MODE OFF
1 : ENDLESS MODE ON
Before V2.00, only the START position could be specified, but in V2.00 or later, the ENDLESS MODE
can also be selected.
The ENDLESS MODE can be specified in the OPEN created in the CLIP unit and the File created by the
commands such as the VFL Download Command.
When performing Open Play by specifying a CLIP while the ENDLESS MODE is specified, only the
specified CLIP is played back repeatedly. When this opened file is played back, “REPEAT PLAY” is
displayed on the OSD.
When performing Open Play by specifying a VFL and the ENDLESS MODE is specified, repeat play-
back is performed according to the description of the file created by the VFL. When this opened file is
played back, “VFL RPT. PLAY” is displayed on the OSD.
When performing Open Play by specifying the ENDLESS MODE, an error occurs in the File Open Status
in the following cases:
Status Value Description
0x15 FAIL, ILLEGAL VALUE The START position cannot be found.
0x1F FAIL, OTHER REASONS Memory for repeating cannot be secured.
n
Since the Endless Mode is supported, do not create VFL with the following file names:
“default.dlt” “Ciplist0.dlt” “RepeatTmp.dlt” “RepeatClipXX.dlt” “RepeatVFLXX.dlt”
(Do not leave out “.dlt” from the above file names. “XX” in “RepeatClipXX.dlt” and
“RepeatVFLXX.dlt” must be 00 to 99.)