Pairing
Check the following before operating the unit.
–The TX/RX switch is set to “RX.”
–This unit is connected to a power source and the 1 indicator (green) goes off.
1Press and hold the ID SET button for 7 seconds or more.
When the 1 indicator (green) and | indicator (blue) start flashing together, release the |
button. This unit enters pairing mode. |
|
Note
Pairing mode is canceled and this unit is turned off after about 5 minutes. If this unit is turned off while performing the procedure, start over from step 1.
2Perform pairing procedure on the BLUETOOTH stereo audio source device to detect this unit.
The list of detected devices appear on the display of the BLUETOOTH stereo audio source device.
This unit is displayed as
If
Notes
•When pairing, be sure to place both the BLUETOOTH devices within 1 m (3 ft) of each other.
•Some devices cannot display the list of detected devices.
3Select
12
US