Sony HZ-WS2000 sound, Symptom, increase, Operation, repeatedly, Cause/Remedy, There is no sound, The volume will not, The buttons do not work, Playback stops suddenly

Operation

Symptom	Cause/Remedy
There is no sound.	c The volume level is set to zero.
	Increase the volume (page 16).
	c The headphone plug is not fully connected.
	Connect the headphone plug fully.
	c The headphone plug is dirty.
	Clean the headphone plug with a soft dry cloth.
	c The audio data sent to the player has been destructed.
	Send the audio data using Music Transfer Hard Disk Player Edition
	again.

The buttons do not work.

cThe HOLD function is set to on. Release the HOLD function (page 21).

cThe player contains moisture condensation.

Let your player sit for a few hours at room temperature.

cThe built-in rechargeable battery is exhausted. Charge the rechargeable battery (page 8).

The volume will not	c The HOLD function is set to on.
increase.	Release the HOLD function (page 21).
The sound is distorted, or	c The bit rate used when encoding the MP3 files was low.
there is noise in the playback	Send MP3 files encoded with a higher bit rate to the player.
sound.	c The Bass Boost function is turned on.
	Turn off the Bass Boost function (page 23).
	c The audio data itself contains noise.
	Noise may have been introduced when creating audio data due to
	the conditions of the computer. Check the source files you sent to
	the player on your computer.
Playback stops suddenly.	c The built-in rechargeable battery is exhausted.
	Charge the rechargeable battery (page 8).
	c The player was turned off by the sleep timer function.
	To continue playback, turn on the power.

Erroneous display, or some characters do not appear in the display.

cThe ID3 TAG information for the track is written in the language that is not supported by the player.

cUser-created characters and some special characters may not be displayed.

cThe player is not functioning normally. Reset the player (page 39).

The player does not play all	c Music Charger function is activated.
the tracks stored in the player.	Exit from Music Charger mode (page 21).
The three LED indicators flash	c The HOLD function is set to on.
repeatedly.	Release the HOLD function (page 21).
	c An AC power adaptor other than the supplied one is used.
	Use only the AC power adaptor supplied with the player.
	c The player is not functioning normally.
	Disconnect the AC power adaptor from the player, turn off the
	power, and then turn on the power again.

38