Problem | Possible Remedies | |
How to reset TV to factory | s | Turn on the TV. While holding down the RESET button on the remote control, |
settings |
| press the POWER button on the right side of the TV. (The TV will turn itself off, |
|
| then back on again.) Release the RESET button. |
|
| |
How to restore Video settings to s | Press the RESET button on the remote control while in the Video Menu (see page | |
factory settings |
| 92). |
|
| |
How to restore Audio settings to s | Press the RESET button on the remote control while in the Audio Menu (see page | |
factory settings |
| 95). |
|
|
|
Cannot cycle through the other | s | Be sure the Label Video Inputs option is not set to Skip (see page 105). |
video equipment connected to |
|
|
the TV |
|
|
|
|
|
Cannot operate Menu | s | If a Menu option appears in gray, this indicates that the TV is in a state in which |
|
| the Menu option is not available. |
|
|
|
Lost password | s | In the password screen (see page 101), enter the following master password: 4357. |
|
| The master password clears your previous password; it cannot be used to |
|
| temporarily unblock channels. |
|
| |
TIMER LED on front panel is lit s | The LED (see page 16) blinks when the TV is turned on, then shuts off when the | |
|
| picture is displayed. If the LED blinks continuously, this may indicate the TV |
|
| needs service. When lit, indicates that the timer is set (page 107). When the timer |
|
| is set, this LED will remain lit even when the TV is turned off. |
|
| |
Digital cable box does not work s | If you are connecting a VCR and digital cable box using a splitter, as described on | |
|
| page 32, you must use a special |
|
| your digital cable box. Contact your cable TV company for details. |
|
|
|
Cannot record digital channels | s | Only analog channels can be recorded to your VCR. |
to VCR |
|
|
|
|
|
Info Other
117