2Secure the TV to the stand.

Use the optional hardware listed below (not supplied):

•M4 × 14 mm anchor bolt and M4 nut (screwed into the TV’s Table-Top Stand).

•A screw or similar (attach it to the TV stand).

•Rope or chain (strong enough to support the weight of the TV). Make sure that there is no

excess slack in the rope or chain.

An alternative way to secure the TV is with an optional Sony Support Belt Kit.

Anchor bolt

Screw hole

 

on the Table-

 

Top Stand

Nut

Screw

 

3Anchor the TV to the wall.

Use the hardware listed below (not supplied).

•Two anchor bolts, size M4 × 10-12 mm (model KDL-26L5000) or M6 × 10-12 mm (model KDL-32L5000). Screw the bolts into the top-most wall-mount holes located on the rear of the TV.

•Rope or chain (attach to one anchor bolt).

•Wall-anchor (attach to the wall stud) strong enough to support the weight of the TV (pass the rope through the wall-anchor, then attach to the other anchor bolt).

Wall-anchor

Wall-mount holes

Anchor bolts

Rope or chain

•Contact Sony Customer Support to obtain the optional Support Belt Kit by providing your TV model name.

For United States call: 1-800-488-7669 or visit: www.sony.com/accessories

For Canada call: 1-877-899-7669

•Measure 2 provides minimal protection against the TV toppling over. For further protection, follow all three measures recommended above.

•If an electric screwdriver is used, set the torque to tighten at approximately 1.5 N·m {15 kgf·cm}.

Started Getting

15