Sony KDL-26S2000, KDL-32S2000, KDL-40S2000, KDL-32S2000, KDL-40S2000 Fall, Antennas, Outdoor use, AC power cord, Ship and vessel, Vehicle and ceiling, Outdoor Antenna Grounding, Placing on a stable surface

When installing the unit on the wall, allow this much space.

30 cm

(117/8 inches)

10 cm	10 cm
(4 inches)	(4 inches)

10 cm (4 inches)

When installing the unit using a stand, allow this much space.

30 cm

(117/8 inches)

10 cm	10 cm	15 cm
(4 inches)	(4 inches)	(6 inches)

Never install the unit as follows:
Air circulation is blocked.	Air circulation is blocked.

Outdoor use

Do not install this unit outdoors. If the unit is exposed to rain, it may result in a fire or an electric shock. If the unit is exposed to direct sunlight, the unit may heat up and cause damage to the unit.

Vehicle and ceiling

Do not install this unit in a vehicle or hang from the ceiling.

Bumping of the vehicle may cause the unit to fall down and cause injury.

Ship and vessel

Do not install this unit in a ship or vessel. If the unit is exposed to seawater, it may cause a fire or damage the unit.

Preventing the TV from toppling over

Take measures to prevent the unit from toppling over and causing injury. To prevent the unit from toppling over, secure the unit to the wall or pillar.

Installing on a level surface

If you install the unit on an inclined surface, the unit may fall or drop and cause injury or damage.

Placing on a stable surface

If you place the unit on an unstable surface, the unit may fall and cause injury or damage.

Fall

Do not hang anything on the unit.

The unit may fall from the stand or wall-mount, causing damage or serious injury.

AC power cord

Unplug the AC power cord when moving the unit. Do not move the unit with the AC power cord plugged in. It may damage the AC power cord and result in a fire or an electric shock. Do not allow anything to rest on or roll over the power cord, and do not place the unit where the power cord is subject to wear or abuse.

AntennasOutdoor Antenna Grounding

If an outdoor antenna is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits.

WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM IS ALMOST INVARIABLY FATAL.

Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

Section 810 of the National Electrical Code (NEC) in USA and Section 54 of the Canadian Electrical Code in Canada provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Antenna Grounding According to the National Electrical Code, ANSI/NFPA 70

	Antenna lead-in wire
Ground clamps
	Antenna discharge unit
Electric service	(NEC Section 810-20)
	Grounding conductors
equipment
	(NEC Section 810-21)
	Ground clamps
	Power service grounding
	electrode system
NEC: National Electrical Code	(NEC Art 250 Part H)

(Continued)

7