Other Information

Preparation for Wall Mounting

Sony Wall-Mount

Bracket Model

SU-WL500

This TV can be installed on a wall by using a Wall-Mount Bracket (sold separately). Before mounting the TV on a wall, the Table-Top Stand must be removed from the TV.

Do not remove the Table-Top Stand for any reason other than to wall- mount the TV.

Follow the simple steps below to remove the Table-Top Stand:

1Disconnect all the cables from the TV.

2Secure the Mounting Hook to the rear of the TV.

3Adjust the angle of the Mounting Hook.

4Start removing the screws behind the TV (See illustration below). Do not remove any other screws from the TV.

5When screws are removed, lift the TV off the stand. Make sure that you carry out this task with at least two people. Do not attempt to lift the TV by yourself.

For bracket installation, refer to the instruction guide provided by the Wall- Mount Bracket model for your TV. Sufficient expertise is required in installing this TV, especially to determine the strength of the wall for withstanding the TV’s weight. For product protection and safety reasons,

Sony strongly recommends that you use the Wall-Mount Bracket model designed for your TV and the wall-mounting of your TV should be performed by Sony dealers or licensed contractors.

Be sure to use the screws supplied with the Wall-Mount Bracket when attaching the mounting hooks to the TV set. The supplied screws are designed so that they are 8 mm to 12 mm in length when measured from the attaching surface of the mounting hook. The diameter and length of the screws differ depending on the Wall-Mount Bracket model. Use of screws other than those supplied may result in internal damage to the TV set or cause it to fall, etc.

8-12 mm

Screw (supplied with the Wall-Mount Bracket)

Mounting Hook

Rear of the TV set

Information Other

(Continued)

39