Programming the Remote Control

The remote control can be programmed to operate other equipment and is pre-programmed to operate the following Sony equipment.

Function Button Sony Equipment Code Number

DVD

DVD Player

31033

 

 

 

AMP

Receiver

52172

 

 

 

STB

Digital Satellite

01639

 

 

 

Programming Other Equipment

DISPLAY

LIGHT

POWER TV POWER

 

DVD

AMP

STB

TV

2

 

FUNCTION

 

PREV

REPLAY ADVANCE NEXT

 

 

PLAY

 

 

SYNC MENU PAUSE

STOP

 

THEATER SOUND PICTURE

WIDE

 

 

 

CC

FREEZE

 

2

4

3

VOL CH

Follow the steps below to program your TV remote control.

1Find the code that corresponds to your equipment from page 27. If more than one code is provided, try programming the first code listed.

2Press and hold DVD, AMP or STB simultaneously with the INPUT button and release. When in the programming mode, the FUNCTION button blinks for approximately 30 seconds until a code is entered.

3Enter the five digit code using 0-9. while the FUNCTION button is lit. If the code is not entered within 30 seconds, you must repeat step 2.

4Press or ENT to confirm the code. If successfully programmed, the FUNCTIONbutton blinks twice; if not, it blinks five times.

~

•Any of the FUNCTION buttons can be programmed to operate other equipment regardless of the labeling. For example, DVD can be programmed to operate a Blu- ray player.

Confirm the Programming

If you can turn your equipment on and off using the green POWER button, the programming is complete. If not, try the next code listed.

~

•In some cases, you may not be able to program your remote control. If this is the case, use your equipment’s own remote control.

Auto Backlight

The backlight can be set to light up when a button is pressed.To set backlight:

Press LIGHT and MUTING simultaneously until the four FUNCTION buttons blink red.

To turn off backlight:Press LIGHT and MUTING until the TV button blinks red.

Backlight Time Out

The remote control can be set to remain lit longer than the default time setting of approximately five seconds with the FUNCTION buttons.

To change backlight time setting:

1Press LIGHT, VOL+, and then CH+ simultaneously until the FUNCTION button blinks red.

2Select the FUNCTION button that corresponds to your preferred time out setting and press .

DVD 5 seconds (default)

AMP 10 seconds

STB 15 seconds

TV 20 seconds

Reset the Remote Control

To reset the remote control to the factory default settings, press SOUND, TV POWER, and then . The FUNCTION buttons blink red simultaneously when successfully reset.

26