Other Info
General
Problem | Possible Remedies |
How to reset TV to | s Turn off the main power of the TV set. While holding down RESET on the |
factory settings | remote control, turn on the main power of the TV set. Turn on the TV. While |
| holding down RESET on the remote control, press POWER on the media |
| receiver unit. (The TV will turn itself off, then back on again.) Release RESET. |
|
|
How to restore Video settings | s Press RESET on the remote control while in the Video Menu (see page 84). |
to factory settings |
|
|
|
How to restore Audio settings | s Press RESET on the remote control while in the Audio Menu (see page 86). |
to factory settings |
|
|
|
Cannot cycle through the other | s Be sure the Video Label option is not set to Skip (see page 96). |
video equipment connected to |
|
the TV |
|
|
|
Cannot operate Menu | s If a menu option appears in gray, this indicates that the menu option is not |
| available. |
|
|
Lost password | s In the password screen (see page 92), enter the following master password: 4357. |
| The master password clears your previous password; it cannot be used to |
| temporarily unblock channels. |
|
|
LED on the TV is lit | s The STANDBY LED (see page 16) lights up when the TV is in standby mode. If |
| the LED blinks continuously, this may indicate the TV needs a service. |
| s The TIMER LED (see page 16) indicates that the timer is set. When the timer is |
| set, this LED will remain lit even when the TV is turned off. |
|
|
106