6:Auto-programming the TV

After selecting the language, a message confirming that the TV starts auto program appears on the screen. You must tune the TV to receive channels (TV broadcasts). Do the following to search and store all available channels.

Press to select “Yes”.

The TV starts searching for all available channels. This may take some time. Do not press any buttons on the TV or remote until it is completed.

Once all available channels have been stored, the TV returns to normal operation, displaying the channel stored on channel number 1.

Tip

If you press any of the buttons during auto-programming, auto-programming operation is canceled. To perform auto- programming again, activate “Initial Reset” in the “Setup” menu (page 45).

When a message appears for you to confirm the antenna connections

No channels are found. Check all the antenna connections and press to start auto-program again.

To change the order in which the channels are stored on the TV

See page 42.

Started Getting

m

Initial Setup

Program

TV System

01Auto

VHF Low

Press any key to cancel

End: WEGA GATE

17 GB