Remote Control Configuration for AV devices

To eliminate the amount of remote controls you need, this remote control will operate the main functions of some Sony’s DAV, Sony’s AV receivers as well as Sony’s STB (see the table on the following page with the available devices).

To operate these devices with this remote needs to be configured

fig. 2

To do this:

•Before you start, look up the 3 digit code of your device from the list on the following page.

•Sony will endeavour to update the software according to market changes. Therefore, please refer to the code table included with the remote control for latest code set.

•A small label is added inside the battery door to allow you to record your brand codes.

1 2 3

4 5 6

7 8 9

0

1Press and hold the t button of the remote control for approximately 6 seconds until the green AUX light of the Media

Selector starts flashing (see fig. 1).

2While the AUX light is flashing, enter the 3 digit code for your device

(see the list on the following page) using the number buttons on the remote control (see fig. 2).

If your selected code is entered correctly, the green AUX light will be lit momentarily (see fig.3), otherwise repeat all the above steps.

3Turn on your device and check that the main functions work (see the table on the following page to check the main functions according to each equipment)

fig. 1

 

 

V

D

 

 

 

 

V

 

 

R

T

 

D

 

 

 

 

U

C

 

 

 

 

A

 

 

 

 

X

V

 

 

 

 

 

 

 

MODE

 

 

 

 

 

 

6 sec.

 

 

fig. 3

 

 

V

 

D

 

 

 

 

V

 

 

T

 

 

D

 

 

R

 

 

U

 

C

 

 

 

A

 

 

 

 

X

V

 

 

 

 

MODE

GB

RM-945

•If your device is not working or some of the functions do not work please check that you entered the correct code.

4Always remember to press the T or t button until the green light iluminates according to the equipment you want to operate with this remote control: TV or AUX. Refer to page 24 for how to operate the VCR and DVD modes.

Additional Information 25