Setting Up the Channel List
Using Auto
Program
zTo exit the Tilt Correction and Vertical Correction screens, press the MENU button.
zFor more details on using Auto Program, see page 84. For more details on using Tilt Correction and Vertical Correction, see pages
After you finish connecting your TV, you need to run Auto Setup to set up your channels. The Auto Program screens appear when you turn on your TV for the first time after hooking it up.
To run Auto Program the first time you turn on your TV
1Press POWER to turn on the TV. The Initial Setup screen appears.
2Using the joystick on the remote control, move the highlight to
the desired language, then press 
to select that language.
3The next screen instructs you to connect your cable/antenna. Check that you’ve connected your signal source as described on pages 16 to 22.
To start Auto Program, move the joystick to highlight Yes and then press 
.
Auto Program automatically creates a list of receivable channels.
When Auto Program is finished, the Tilt Correction screen appears.
4Move the joystick B b to correct any tilt of the picture. You can choose a correction between +7 and
When finished, press 
. The Vertical Correction screen appears.
5Move the joystick V v to make a vertical correction to the picture.
You can choose a correction between +5 and 
.
The lowest numbered channel is displayed.
To reset the TV to factory settings
1Press POWER to turn on the TV.
2Hold down RESET on the remote control.
3Press TV POWER on the TV. (The TV will turn itself off, then back on.)
4Release RESET.
Setup
SETUP
SETUP
SETUP
SETUP
41