Other Information

Programming the

The remote control is preset to operate Sony brand video equipment.

Remote Control

 

 

 

Sony

Switch Position

Programmable

 

 

Equipment

on Remote Control

Code Number

 

 

 

 

 

Beta, ED Beta VCRs

VTR1

303

 

 

 

 

 

8 mm VCR

VTR2

302

 

 

 

 

 

VHS VCR

VTR3

301

 

 

 

 

 

DVD Player

DVD/MDP

751

 

 

 

 

If you have video equipment other than Sony brand that you want to control with the TV’s remote control, use the following procedures to program the remote control.

✍The equipment must have infrared (IR) remote capability in order to be used with the remote control.

zTo check if the code number works, after step 5 aim the TV’s remote control at the component and press the POWER button that corresponds with that component. If it responds, you’re done. If not, try using the other codes listed for your component.

1Turn to “Programmable Codes” on page 43, and find the three- digit code number for your equipment. If more than one code number is listed, use the number listed first to complete the following procedures.

✍You must perform step 3 within 10 seconds of step 2, or you must start again from step 2.

2Press CODE SET.

3Press VTR/DVD or SAT/CABLE. (For models KV-32FV26 and 36FV26, move the slide switch to the desired input).

4Enter the three-digit code number.

5Press ENTER.

Tips

❑If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.

❑If you enter a new code number, the code number you previously entered at that setting is erased.

❑In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment’s own remote control unit.

❑Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reset.

42