Sony KV 27FS200 Problem Possible Solutions Cable stations, Don’t seem to work, Remote control

			Other Information
Problem	Possible Solutions
Cable stations	❏ Make sure Cable is set to On in the Channel Setup menu (page 27).
don’t seem to work	❏ Perform Auto Program to add channels that are not presently in the
	memory (page 17).
Remote control	❏ Press TV (FUNCTION) when operating your TV.
does not operate	❏ Check the orientation of the batteries.
	❏ Batteries could be weak. Replace them (page 2).
	❏ Move the TV three to four feet away from fluorescent lights.
Cannot change	❏ Make sure you have not inadvertently switched your TV from the
channels with the	channel 3 or 4 setting if you are using another device to change channels.
remote control	❏ If you are using another device to control channels, be sure that you have
	pressed the FUNCTION button for that device. For example, if you are
	using your VCR to control channels, be sure to press the VCR/DVD
	FUNCTION buttons (page 4).
Cannot access	❏ If you use the	button to close the Basic menu, only the Basic menu
other menus when	appears when you press		again. To access the other menus, select the
using the Basic	Advanced Menu option (page 37).
menu
The remote control	❏ Press the TV FUNCTION button. You may have inadvertently pressed
doesn’t work in PIP	the VCR/DVD FUNCTION button, which changes the PIP buttons to
mode	VCR mode (page 21).
There is no window	❏ Be sure your PIP window picture is set to a video source/channel that has
picture or it is just	a program airing.
static	❏ You may be tuned to a video input with nothing connected to it. Try
	cycling through your video inputs using the yellow PIP TV/VIDEO
	button with the red dot (page 21).

I get the same program in the window picture as in the main picture

❏Both may be set to the same channel. Try changing channels in either the main picture or the window picture (page 21).

❏Your TV may be set up to select all your channels through a cable box. The cable box will only unscramble one signal at a time, so you cannot use the PIP feature. If possible, run a direct cable to the VHF/UHF jack on your TV. This will only work if your cable system provides an unscrambled signal (page 9).

I cannot get	❏ Be sure that you did not set the video label in the Setup menu (page 36)
anything but TV	to skip your video inputs. If a video input has been set to “Skip”, it will
	be skipped when pressing the TV/Video buttons for either the main or
	PIP pictures.
The TV needs to be	❏ Clean the TV with a soft dry cloth. Never use strong solvents such as
cleaned	thinner or benzine, which might damage the finish of the cabinet.

43