Troubleshooting (continued)
The tape does not record nor play, or there is a decrease in sound level.
•The heads are dirty. Clean them (see page 46).
•The record/playback heads are magnetized. Demagnetize them (see page 46).
The tape does not erase completely.
•The record/playback heads are magnetized. Demagnetize them (see page 46).
There is excessive wow or flutter, or the sound drops out.
•The capstans or pinch rollers are dirty. Clean them (see page 46).
Noise increases or the high frequencies are missing.
•The record/playback heads are magnetized. Demagnetize them (see page 46).
Tuner
Severe hum or noise (“TUNED” or “STEREO” flashes in the display).
•Adjust the antenna.
•The signal strength is too weak. Connect an external antenna.
A stereo FM program cannot be received in stereo.
•Press STEREO/MONO so “STEREO” appears in the display.
If other problems not described above occur, reset the system as follows:
1Unplug the power cord.
2Plug the power cord back in.
3Press t/CLOCK SET, ENTER, and 1/uat the same time.
The system is reset to the factory settings. All the settings you made, such as the preset stations, clock, and timer are cleared. You should set them again.
Specifications
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from 70 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.9% total harmonic distortion from
250 milliwatts to rated output.
Amplifier section
120 + 120 watts
(8 ohms at 1 kHz, 10% THD)
Total harmonics distortion
Less than 0.07%
(8 ohms at 1 kHz, 50 W)
DIN power output (Rated)
90 + 90 watts
(8 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference) 120 + 120 watts
(8 ohms at 1 kHz, 10% THD)
Music power output (Reference)
200 + 200 watts
(8 ohms at 1 kHz, 10% THD)
The following measured at AC 120/220/240 V, 50 Hz
DIN power output (Rated)
140 + 140 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference) 170 + 170 watts
(6 ohms at 1 kHz, 10% THD)
The following measured at AC 120/220/240 V, 50 Hz
DIN power output (Rated)
160 + 160 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (Reference) 200 + 200 watts
(6 ohms at 1 kHz, 10% THD)
48