To erase a preset number

1Press and hold TUNER MEMORY until the preset number flashes in the display.

2Press TUNING +/– to select the preset number you want to erase. Select “ALL ERASE” to erase all preset numbers.

3Press ENTER/NEXT.

When you erase a preset number, all the following preset numbers shift up and reduce by one.

To change the AM tuning interval(Except for the European and the Middle Eastern models)

The AM tuning interval is factory-preset to 9 kHz (10 kHz in some areas). To change the AM tuning interval to 10 kHz (or 9 kHz), press TUNER/BAND repeatedly until “AM” appears, then turn off the system. While holding down ENTER, turn the system back on. When you change the interval, the AM preset stations will be erased. To reset the interval, repeat the same procedure.

Note

The preset stations are canceled when you disconnect the power cord or if a power failure occurs for more than half a day.

Saving power in standby mode (For LBT-W900AV/ XB800AV only)

In standby mode, you can reduce the power consumption to a minimum (Power Saving mode) and thus save energy.

1/u

POWER SAVE/DEMO

 

 

(Power)

(STANDBY)

DISPLAY

 

 

 

 

 

/Press POWER SAVE/DEMO (STANDBY) while the system is turned off.

The system switches to the Power Saving mode and the clock display disappears.

The system is turned on/off by pressing 1/u.

To cancel the Power Saving mode

Press DISPLAY.

The clock display reappears.

continued

11