Cleaning the cabinet

Clean the cabinet, panel and controls with a soft cloth slightly moistened with mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as thinner, benzene or alcohol.

To save a tape permanently

To prevent a tape from being accidentally recorded over, break off the cassette tab from side A or B as illustrated.

Break off the cassette tab

If you later want to reuse the tape for recording, cover the broken tab with adhesive tape.

Before placing a cassette in the tape deck

Take up any slack in the tape. Otherwise, the tape may get entangled in the parts of the tape deck and become damaged.

When using a tape longer than 90 minutes

The tape is very elastic. Do not change the tape operations such as play, stop, and fast-winding frequently. The tape may get entangled in the tape deck.

Cleaning the tape heads

Clean the tape heads after every 10 hours of use. Be sure to clean the tape heads before you start an important recording or after playing an old tape. Use a separately sold dry-type or wet-type cleaning cassette. For details, refer to the instructions of the cleaning cassette.

Demagnetising the tape heads

Demagnetise the tape heads and the metal parts that have contact with the tape after every 20 to 30 hours of use with a separately sold demagnetising cassette. For details, refer to the instructions of the demagnetising cassette.

30GB

Specifications

AUDIO POWER SPECIFICATIONS (LBT-XGR600 USA model only)POWER OUTPUT AND TOTAL HARMONIC DISTORTION:

With 6 ohm loads, both channels driven, from 120 – 10,000 Hz: rated 160 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 milliwatts to rated output.

Amplifier sectionNorth American model:LBT-XGR600

Front speaker

Continuous RMS power output (reference):

175 + 175 watts (6 ohms at

1 kHz, 10% THD)

Total harmonic distortion less than 0.07% (6 ohms at 1 kHz, 80 W)

Other models:

LBT-XGR88

The following measured at AC 120, 220, 230 – 240 V 50/60 Hz

DIN power output (rated): 145 + 145 watts (6 ohms at 1 kHz, DIN)

Continuous RMS power output (reference):

180⋅ 2 + 180⋅ 2 watts (6 ohms at 1 kHz, 10% THD)

LBT-XGR66

The following measured at AC 120, 220, 230 – 240 V 50/60 Hz

DIN power output (rated): 220 + 220 watts (6 ohms at 1 kHz, DIN)

Continuous RMS power output (reference):

250 + 250 watts (6 ohms at

1 kHz, 10% THD)

Inputs

PHONO IN (phono jacks):

sensitivity 3 mV, impedance 47 kilohms

MIC (phone jack): sensitivity 1 mV, impedance 10 kilohms

GAME INPUT AUDIO L/R (phono jacks): sensitivity 250 mV, impedance 47 kilohms

GAME INPUT VIDEO (phono jack): 1Vp-p, 75 ohms