You do not need to configure the settings on pages 39 to 41 if you performed the easy setup (1 page 17 to 19).
This section explains how to make advanced settings for using the NetAV function.
NetAV SettingsSet the port of the Base Station when the NetAV function is to be used.
1If there are multiple Base Stations and 5021 is already being used, change the port number of the NetAV server.
You can specify port numbers in the range 5021 to 5999.
At the time of purchase this item is set to 5021.
2Click this to save the changes.
Setting a Router Incompatible with the UPnP Function
When port forwarding needs to be set on the router, follow the procedure below to set the Base Station’s IP address.
zTip
The IP address, subnet mask, and default gateway used in the procedure below are only examples. Before you
configure these settings, check the IP address settings of the router.
1 Set [IP Address Settings] to [Manual] in the [Internet Connection] frame and then enter the following information (1 page 38).
IP Address: 192.168.0.64*1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.1*2
*1 Example when the IP address of the router is 192.168.0.1. If the IP address of the router is 192.168.1.1, enter 192.168.1.64 for the IP address. If you are using multiple Base Stations, set a different setting for each Base Station, such as 64 and 65.
*2 Example when the IP address of the router is 192.168.0.1. If the IP address of the router is 192.168.1.1, enter 192.168.1.1 for the default gateway.
2 Set [Manual] for [DNS Configuration] and enter the following information.
DNS1: 192.168.0.1*3
DNS2: It is OK to leave the field blank.
*3 Example when the IP address of the router is 192.168.0.1. If the IP address of the router is 192.168.1.1, enter 192.168.1.1 for the DNS1.
3 Click [Set].
4 Set port forwarding on the router.
Enter the Port Number that you set while making NetAV Settings.
For details, refer to the operating instructions for your router.
Settings Station Base Advanced
39