Setting DIP Switches and SCSI ID

Refer to the “Operating Instructions” (PDF) and perform the appropriate DIP switch and SCSI ID settings.

The default factory settings of the SCSI IDs are as follows.•AIT drive: 1•Loader: 0

Turning the Power On/ Off

Turn On the Power

Turn on the AIT autoloader, then turn on the host computer.1 Press the power switch on the rear of the autoloader, as illustrated.

The message display changes as follows and the startup process begins. (Startup takes several minutes.)

During startup, the following appears on the message display.

Moves gradually up and down during the elevator check.

Indicates the startup phase, from 0 to 3.

When startup is complete, the message display indicates the number of cartridges in the AIT autoloader.

Starting up

Startup complete

When startup is complete, press the DOOR button to open the front door and insert cartridges. For details, refer to the “Operating Instructions” (PDF).

2 After pressing the power switch on the rear panel ofthe autoloader, wait at least 10 seconds before turning on the host computer.

Notes

•If you start the host computer before the autoloader, the SCSI ID is not detected correctly. Therefore, you must always start the autoloader before starting the host computer.

•If the autoloader does not work as above, see “Troubleshooting” in the “Appendix” in the “Operating Instructions” (PDF).

Setting DIP Switches and SCSI ID

7