The headphones automatically turn off when they are taken off
— Auto power on/off function
Do not pull up the
Sound is automatically muted if noise increases
— Mute function
If the infrared rays are obstructed, or the headphones are used outside their effective range, noise will increase and sound will become hard to hear. To avoid potential ear damage as a result of noise, this function mute any sound from the headphones. Sound is automatically restored when you move nearer the transmitter or remove the obstruction.
Using the vibration function
Set the VIBRATION switch to ON and adjust the level of vibration using the vibration volume. You can enjoy powerful bass sound when you listen to movies or games through the headphones.
Using SRS surround function
Set the switch to ON to reproduce a wide surround sound field through the headphones.
Using the ATT (Attenuator) switch
If the input volume is low, set the ATT switch on the transmitter to OFF.
If no audio signal is input for more than approximately 5 minutes
The transmitter turns off automatically.
Note
The brightness of the infrared emitters may not be uniform, however, this is not a malfunction.
Operating the system |
| 11GB |
|
|
|