Noise Canceling
Headphones
Operating Instructions
Mode d’emploi (verso)
Installing a battery
1 Open the lid of the battery case on the right inner side of the headphone.Holding the side of the battery case lid, slide the lid to unlock it.2 Insert one R03 (size AAA) battery by matching the + and – on the battery to the + and – in the battery case.
3 Close the lid.Listening to music
1 Connect the headphones to the AV equipment.When connecting to dual or stereo mini jacks ofL R
Plug adaptor*To headphone jack on airplane seats*May not be compatible with some
When connecting to the headphones jack (stereo mini jack) of a Discman, WALKMAN**, etc.
Stereomini plug **WALKMAN is a registered trademark of Sony Corporation.2 Turn on the power of the headphones. The POWER indicator lights in red. When the power is turned on, ambient noise is reduced, and you can listen to music more clearly at a lower volume.
Folding and unfolding the headphones
FoldingHold the battery case with your right hand and fold the headphones toward you one after another as illustrated.
R
Battery case2 1
L
UnfoldingPrecautions
•Clean the headphones with a soft dry cloth.•Do not leave the plug dirty otherwise the sound may be distorted.•Be sure to consult a Sony dealer when the earpads become dirty or damaged, or when the headphones require repair work.
•The CE mark on the unit is valid only for products marketed in the European Union.
•Do not leave the stereo headphones in a location subject to direct sunlight, heat or moisture.
Notes on headphonesPreventing hearing damageAvoid using headphones at high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce the volume or discontinue use.
Do not listen with the headphones while driving or cyclingAs your headphones reduce outside sounds, it may cause traffic accident. Also avoid using them where hearing must not be impaired, for example, at a railroad crossing, a site of construction, etc.
Troubleshooting
No sound• Check the connection of the headphones and the |
AV equipment. |
• Check that the connected AV equipment is |
turned on. |
• Turn up the volume of the connected AV |
OFF ON POWER
3 Put on the headphones so that the ear pads cover your ears.Hold the battery case with your right hand and unfold the headphones toward you one after another as illustrated.
R
Battery case
equipment. |
•Check if the battery has expired (the POWER indicator dims). Replace the battery with a new one.
MDR-NC05
Sony Corporation © 1997 Printed in MalaysiaEnglish..Battery | Approx. hours |
Sony alkaline battery LR03/ | 20 hours |
| |
Sony battery | 10 hours |
Battery case
4 Turn on the power of the AV equipment.1
L
2
•If you cover the microphone of the headphones with your hands, howling may occur.
In this case, move your hands away from the microphone.Noise canceling is not effective• Check if the power is turned on. Set the POWER |
switch to ON if the power is turned off. |
• The noise canceling function is only effective for |
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
For the customers in the U.S.A.
WARNINGThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Owner’s Record
The model number is located at the left inner side of the headband.The serial number is located inside the battery box. Record these numbers in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this product.
Model No.Features
•Noise canceling headphones reduce ambient noise, and provide a quieter environment to enhance audio entertainment. Ambient sound is synthesized with an
•Plug adaptor is supplied to connect directly to stereo or dual jack of
for dual jacks | for stereo mini jacks | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
•Do not use the headphones when use of electronic equipment is prohibited or when use of personal headphones for
If you have any questions or problems concerning the system that are not covered in this manual, please consult the nearest Sony dealer.
After listening to musicTurn off the power of the headphones.Notes•The noise canceling function is only effective for noise in the low frequency band. Although noise is reduced, it is not canceled completely.
•Do not cover the microphone of the headphones with your hands. The noise canceling function may not work properly.
•If you cover the microphone of the headphones with your hands, howling may occur.
In this case, move your hands away from the microphone.
Microphone•You can use the headphones without turning on the power. In this case, the noise canceling function is not active, and the headphones operate as passive headphones.
•With some discs or tapes, the sound may be distorted when you activate the noise canceling function.
In such cases, turn down the volume or turn off the sound effect such as Digital MEGA BASS function etc.
noise in the low frequency band. Although |
noise is reduced, it is not canceled completely. |
• If you cover the microphone of the headphones |
with your hands, the noise canceling function |
may not work properly. |
• You may not notice the noise canceling effect in |
quiet locations or locations with particular types |
of noise. Also in some cases, you may find the |
external noise get louder. In such cases set the |
power switch to OFF. |
Specifications
General |
|
Type | Dynamic, open |
Driver units | 30 mm dia: dome type |
Impedance | 17 ohms at 1 kHz |
| (when the power is on) |
| 35 ohms at 1 kHz |
| (when the power is off) |
Sensitivity | 100 dB/mW (when the power is |
| on) |
| 98 dB/mW (when the power is off) |
| 30 – 15,000 Hz |
Frequency range of active noise attenuation | |
| 40 – 1,500 Hz, more than 10 dB at |
| 300 Hz |
Cord | 1.5m with a |
| mini plug |
Power source | DC 1.5 V, 1 × R03 (size AAA) |
| battery |
Mass | Approx. 125 g (4.4 oz) including |
| battery |
*May not be compatible with some