Watching the TV

Setting the TV channels

To watch TV programs, you need to run “Auto Program” to set up your channels.

Perform the following “Auto Program” procedure before you watch TV programs for the first time.

For details on the use of the menu and buttons, see “Navigating the menu” on page 16.

Message of “Auto Program Not Run” appears until you select “Auto Program.”

1Press the MENU button.

2Press the M/m buttons to select (Channel) and press the OK button.

The “Channel” menu appears on the screen.

3Press the M/m buttons to select “Auto Program” and press the OK button.

The “Auto Program” menu appears on the screen.

4Press the M/m buttons to select “OK” and press the

OK button.

The display starts scanning and preparing channels automatically.

Channel number and on-screen message appear.

5Press the MENU button to exit the menu screen after Auto Program is completed.

Note

This procedure may take some minutes. Do not press any buttons during the process. Otherwise, “Auto Program” will not be completed properly.

Changing the TV channel

Press the 0-9 buttons to input a channel number.

The channel changes after 3 seconds. Press the ENT (enter) button to select immediately.

Use the CH +/– buttons to scan through the channels.

CH

or

Tips

•When you press and hold the CH + or – button, the channel number will change rapidly.

•When you switch the TV channel while listening or operate your PC, video or decoding device, switch the input to TV, then press CH +/– or 0-9 buttons. If you press CH +/– or 0-9 buttons, the input cannot be automatically switched to TV.

Skipping unnecessary channels

You can skip unnecessary channels when selecting channels using the CH +/– button.

1Press the MENU button.

2Press the M/m buttons to select (Channel) and press the OK button.

The “Channel” menu appears on the screen.

3Press the M/m buttons to select “Channel Skip/

Add” and press the OK button.

The “Channel Skip/Add” menu appears on the screen.

4Press the M/m buttons to select the channel you want to skip and press the OK button.

Tip

To scroll through the list, press and hold the M/m buttons.

5Press the M/m buttons to select “Skip” and press the OK button.

If you want to restore skipped channel, select “Add.”

6Press the MENU button to exit the menu screen.

US

Choosing between cable and UHF/

VHF

To set the UHF/VHF channels, you need to set the “Cable” menu to “Off” by following the instructions below.

1Press the MENU button.

2Press the M/m buttons to select (Channel) and press the OK button.

The “Channel” menu appears on the screen.

3Press the M/m buttons to select “Cable” and press the OK button.

The “Cable” menu appears on the screen.

4Press the M/m buttons to select the desired mode and press the OK button.

•On: The cable TV channels can be set.

•Off: The UHF/VHF channels can be set.

Notes

•You cannot set and receive cable TV channels and UHF/VHF channels at the same time.

•After switching between the cable and the UHF/VHF mode, be sure to perform “Auto Program.”

15