Presetting radio stations (continued)

To erase a preset station

1Press and hold TUNER MEMORY until a preset number appears in the display.

2Press . or > repeatedly to select the preset number you want to erase.

Select “ ALL ERASE” when you want to erase all the preset stations.

3Press ENTER.

“COMPLETE” appears.

When you erase a preset number, the preset number decreases by one and all preset numbers following the erased one are renumbered.

To change the AM tuning interval (except for the European and Middle Eastern models)

The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down ENTER, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.

Tip

The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.

Listening to the radio

— Preset Tuning

Preset radio stations in the tuner’s memory first (see “ Presetting radio stations” on page 11).

1 Press TUNER/BAND repeatedly to select “FM” or “AM”.

2 Press . or > (or press PRESET +/

–on the remote) repeatedly to tune in the desired preset station.

Preset number Frequency*

*When only one station is preset, “ ONE PRESET” appears in the display.

To listen to non-preset radio stations

Use manual or automatic tuning in step 2. For manual tuning, press m or M (or TUNING +/–on the remote) repeatedly. For automatic tuning, press and hold m or M (or TUNING +/–on the remote).

Tips

•When an FM stereo program has static noise, press STEREO/MONO repeatedly until “ MONO” appears. There will be no stereo effect, but the reception will improve.

•To improve broadcast reception, adjust the supplied antennas.

12