Change the preset station
Start over from step 1.
Stop setting presets
Press MENU.
Tune in a station with a weak signal
Follow the procedure described in “ Setting presets through manual tuning” .
To
Do this
6 Press ENTER.
7 Repeat steps 1 to 6 to store other stations.
Other Operations
Press PRESET –or + repeatedly to select the desired preset number.
5
3 Press MENU.
4 Press PRESET –or + repeatedly until “ MEMORY” appears, then press
ENTER.
A preset number appears.
Press TUNING –or + repeatedly to tune in the desired station.
2
Setting presets through manual tuning
1 Press TUNER/BAND repeatedly to select “ FM” or “ AM” .
To change the AM tuning interval

The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down ENTER, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.

Note

You cannot change the AM tuning interval in Power Saving Mode.

Tips

•The preset stations are retained for about a day even if you disconnect the mains lead or if a power failure occurs.

•You can label the preset stations (see page 16).

•To improve broadcast reception, reorient or move the supplied antennas near a window or outdoors.

Tuner

15US